TPMS

We've recently released our own TPMS with an app that you can install on our head units. This article will provide you guide on how to install and troubleshoot common issues.

Step 1: Plug the USB receiver into one of our head unit USB plugs coming out of our head unit.

Step 2: Install the app from the link we provided (Do not open yet just install).

Step 3: Plug in USB receiver. When it gives pop-up saying "Open TW TPMS to handle USB Serial", tick the box for "Always open TW TPMS when USB Serial is connected" then tap OK.

Step 4: Screw the sensors onto the tyre valves of your tyres and open the app. Wait a few seconds for the sensors to be read. 

Step 5: Everything should be ok take the car for a drive and make sure pressures update and then you can follow the instructions in video below or manual included to set.

Step 6: If you have a kit with a repeater then you will need to set this up near the hitch on the caravan with a 12V power source. We suggest taking it from trailer plug and we also include a 9V battery clip so you can just do a rough test setup to test that range is ok before you mount and hard wire it. 

Q: I installed my TPMS following the steps above but there's "leaking" message on the app and keeps beeping

A: Simply uninstall and re-install the app. Then check if issue is fixed.

Q: The TPMS app keeps lagging

A: Simply uninstall and re-install the app. Then check if issue is fixed.