Toyota Hilux 2011 - 2015 - Install Help and Guide
1833 will be the SKU. This will give you some more guidance and help when installing our units into your Hilux
Kurt H
Last Update 2 years ago
Install Video
Q: Glitchy reverse camera
A: Make sure GND wire of reverse cam is connected to Chassis GND instead of the reverse light negative wire.
Note: If you have M Series (MT-1833), make sure you set the right camera settings. See video below for steps but setting should be:
Cam Type: AHD
Cam Format: 1080P
Q: Steering Wheel Control not working
A: Make sure you set the correct canbus setting.
For X Series (VH-1833):
- Go to Settings > Car Settings
- Select Factory Settings > enter 126 for password.
- Go to CANBUS > CANBUS Settings
- Select 2 TOYOTA/CAMRY/RAV4(Simple). Hit OK
Then, go back to Factory Settings > go to KEY > Canbus Key Study > Proceed with learning the buttons.
For M Series (MT-1833):
- Go to Settings > Car Infotainment
- Scroll to bottom and tap About Device.
- Tap on the gear icon and enter 8878 for password
- Go to Can Type > Select number 3. TOYOTA
- Tap SAVE then OK to reboot and steering wheel control should start working
Q: My previous and next button now works as volume up and volume down or vice-versa. How can I change this?
A: See the video below.
Touch Key Button Learning
Aftermarket Reverse Camera Installation